The HobbyKing TR6A and HK-R8A receivers will work with this transmitter too. Yours may be the same or may need different settings. Then press and hold the Menu button down until you hear a confirmation beep. All merchandise should be returned to us by shipping carriers with safe method which provides proof of shipment (just in case your item does not reach us. so you can check with your local shipping carrier.) We will not responsible for the lost of returned merchandise in shipping. The numbers 0000 on the top will increase to 0001. 2. The right stick gets calibrated first. You will see the following screen if you successfully entered into the calibration mode:Calibration steps: 1. Begin by centering both sticks.
Click your UP button until the selection arrow points at END POINTS and then click OK. Click OK to cycle down to CHANNEL 5. The arrow will be pointing at the low END POINT.Use your UP or DOWN button to adjust this number. The number will stay at 0005. 5. Exit and save the calibration result by double pressing the exit button. Reserves the right to refuse service to anyone. The radio can do: Throttle curvesPitch curvesEndpoint adjustmentsSubtrimSwash AFR mixesServo reversingTimerDual rateExponentialFlaperonsV-Tail mixingElevons This radio has got a lot of things happening. The numbers 0001 will now increase to 0002. Now, move the same stick diagonally to the lower left position. Keep in mind, this should work for all the variants of the FlySky FS-TH9x. i.e. Turnigy 9x, Imax-9x, Eurgle and CopterX If not, here’s the procedure all new Turnigy 9x owners should perform.
Move the right stick diagonally to the upper right. Hold it there and then long press the menu button until the confirmation beep is heard. The menu that comes up will give us the options of going into the SYSTEM SETUP (radio icon) or FUNCTIONS SETUP (wrench screwdriver icon) (below photo). To toggle back and forth between the two options, use the THUMBSCREW by spinning it with your thumb. Page of 29 2012-2017 Upload manual Thank you for your help!